Unraid on UGREEN. Done right.

DXP4800 Plus / Pro

Four bays, two M.2 slots, one 10G and one 2.5G LAN port. Fan control after a fan probe.

Community-tested: Nothing verified by a maintainer yet; users confirmed at least one capability.

• LEDs: Community-tested Nov 2026
  Reported working by users of the Plus and the Pro (miskcoo issue 121), and by a Plus owner on 5.5.0 (#266): LED probe ok at 0x3a, 6 LEDs. Evidence
• Fan control: Community-tested Nov 2026
  Reported working by a Plus owner on 5.5.0 (#266): IT8613 found, fan headers and spinning fans checked ok. Same IT8613E as the DXP6800 Pro, header wiring not known: the fan probe finds which output drives which fan and fan control stays off until you confirm its result. The Plus was reported to use outputs 2 and 3; UGREEN's own driver expects cpu on header 2 and case on header 3. Evidence
• Case view: Community-tested Nov 2026
  Front and rear confirmed by a Plus owner. The two M.2 slots of the underside panel are printed M2-KEYM1 (next to the RAM) and M2-KEYM3 on the board, shown as M.2-1 and M.2-3 (UGREEN's photos agree); the third slot, M2-KEYM2, is inside the case. Inside view otherwise after UGREEN's manual, the Pro was not compared. Works on 5.5.0 too (#266). Evidence
• Sensors: Expected
  Not confirmed. A Plus owner reported the ACPI board temperature as a fixed value of about 28 C (5.5.0, #266); the sensors check is being looked at separately.
• Front panel: Partly confirmed Nov 2026
  Beeper: confirmed by a Plus owner. Buttons: the pad registers read real values (power 0xFD6A0980 = 0x04000100, reset 0xFD6D0A10 = 0x84000102) but the buttons did not respond; a panel buttons --watch test is requested and still open. Evidence

Open the live plugin for the DXP4800 Plus / Pro